nanoFramework.Iot.Device.RadioReceiver 1.2.573

Radio Receiver

The radio receiver devices supported by the project include TEA5767.

Documentation

• TEA5767 radio receiver datasheet

Usage

Important: make sure you properly setup the I2C pins especially for ESP32 before creating the I2cDevice, make sure you install the nanoFramework.Hardware.ESP32 nuget:

//////////////////////////////////////////////////////////////////////
// when connecting to an ESP32 device, need to configure the I2C GPIOs
// used for the bus
Configuration.SetPinFunction(21, DeviceFunction.I2C1_DATA);
Configuration.SetPinFunction(22, DeviceFunction.I2C1_CLOCK);

For other devices like STM32, please make sure you're using the preset pins for the I2C bus you want to use.

Hardware Required

• TEA5767
• Male/Female Jumper Wires

I2cConnectionSettings settings = new I2cConnectionSettings(1, Tea5767.DefaultI2cAddress);
I2cDevice device = I2cDevice.Create(settings);

using (Tea5767 radio = new Tea5767(device, FrequencyRange.Other, 103.3))
{
    // The radio is running on FM 103.3MHz
}